 |
|
PCTechBytes Computer Repair Help Tutorials |
PC Help Guides |
Knowledge Base Home | Glossary |
|
Home > All Categories
> PC Troubleshooting > Lost Clusters On Hard Drive |
Lost Clusters On Hard Drive |
|
Lost Clusters on HDD
Frequently running
Scandisk or
chkdsk can help save your data. Hard drives can develop
bad clusters over time, and those utilities can help retrieve
corrupt data, and also prevent data from ever being written to those
bad sectors again. Running these disk management tools will
help reduce crashes and further loss of data. They may also
help make you aware of impending hard drive failure.
Lost clusters in a lost chain
A typical error, such as "lost cluster in a lost
chain" indicates that data is present but there are no pointers pointing
to that data. You can run chkdsk to attempt to recover the files,
or you can simply repair the errors by selecting N when prompted for
action. This will correct the errors but not save the data.
Or you can press Y, which will attempt the associate a folder to that
data. If a folder cannot be found, it will save the data in a
folder labeled .xxx. The "xxx" is a sequential number, so the
folder will probably be named .000 if the folder does not exist.
ScanDisk
This utility exists in Windows 9.x
systems, such as Windows 98 and ME. To access this
utility, navigate to START>PROGRAMS>ACCESSORIES>SYSTEM TOOLS,
then scandisk. You will be given the option to do a
Thorough Scan, which is recommended as it physically scans the
surface of the drive for errors. You can also specify if
you want the errors corrected automatically, which is normally
fine unless you want to attempt to recover the data.
Chkdsk
Chkdsk is available in Windows 2000
and Windows XP. To run a chkdsk, go to My Computer and
right-click the drive you want to scan, then select Properties.
Under the Tools tab, you will see a section for Error Checking.
Click Check Now. Again, you will be given options
Automatically fix the errors, or to attempt to recover the data.
You may be prompted to reboot so this utility can run before
Windows loads. This is normal.
| |
|
| Authored by: David
This question has been viewed 9139 times so far.
|
|
Click Here to View all the questions in PC Troubleshooting
category. |
File Attachments |
| There are no attachment file(s) related to this question. |
| |
|
|
|
Related Questions |
- PC Will Not Boot
- Device Manager Error Codes
- Power Supply Troubleshooting
- Computer Troubleshooting Tips
- Computer Troubleshooting Tips
- Hard Drive Troubleshooting
- DVD Drive Troubleshooting
- Benchtest Your PC
- Power Supply Troubleshooting
- Bypassing The Case Switch
- No Fixed Disk Present
- Top Ways to Break Your PC
- Diagnose Computer Problems
- CPU Beep Code
- Invalid Boot.ini or Hal.dll error
- My Computer Automatically Reboots
|
|
|
|
Disclaimer: PCTechBytes, LLC is not responsible for the damage of your PC or any harm that may come to you or your property as a result of information contained on this site. Computer repair should be performed by a professional service rep only. Working on your own computer could result in a voided warranty, loss of use or permanent destruction of data. |
| |
| Copyright 2008 PCTechBytes, LLC |
|